Category Archives: Metal Dome Assembly

What’s light guild film and what function of it?

LGF, also known as light guide film , is a new product designed to improve the existing light guide film. It is to add a layer of LGF to the current common double layer metal dome structure, so as to achieve good light distribution effect. … Continue reading

Posted in LGF dome array, metal dome array, Metal Dome Assembly, Metal Domes | Tagged | Leave a comment

What’s caused the poor click feeling when pressing metal dome?

The click feeling of metal dome is very important for the using of whole product, a good click feeling not only need the metal dome has very good click feeling, but also related with the assembly of whole product, if … Continue reading

Posted in metal dome array, Metal Dome Assembly, Metal Domes | Leave a comment

What factors will influence the click feeling of the metal dome after assembly on PCB

We always get feedback from customers that the click of dome switch or metal dome is not good after assembly on PCB, what reasons cause this issue? That’s what they care about most. Today I will analyze it from the … Continue reading

Posted in Metal Dome Assembly, Metal Domes, Others | Leave a comment

What problem or issue would have if the metal dome height and PET adhesive size are not suitable?

Recently, we got feedback fron one of our customers that found Plastic of Dome Switch bulge and peel off as below photo when production after assembly dome array on PCB, we could see the place from the red arrow. Why … Continue reading

Posted in metal dome array, Metal Dome Assembly, Metal Domes | Leave a comment

How to improve the metal dome assembly efficienc?

As the labor cost increase every year, more and more customer pursue the assembly efficiency of metal dome. So how to increase the assembly efficiency? There are many methods for metal dome assembly, such as the triangle with legs is … Continue reading

Posted in metal dome array, Metal Dome Assembly, Metal Domes | Leave a comment

Can metal dome be weld on PCB board?

We know there are different assembly methods for metal dome, such as metal dome with legs can insert in PCB’s pin hole to fix, similar like below picture. Most of the dome switch with legs are triangle type. It has … Continue reading

Posted in metal dome array, Metal Dome Assembly | Leave a comment

How to increase the click feeling of metal dome?

We know the click feeling of metal dome largely affects the use of the whole products, so how should we do to improve the click feeling of metal dome? Here are the answers: How to measure the diameter of triangle … Continue reading

Posted in FAQ, metal dome array, Metal Dome Assembly | Leave a comment

Why need to add an plunger (actuator) on metal dome array?

Why the customer want to make an plunger or actuator  on the top layer of metal dome array? There are two main functions: How to measure the diameter of triangle metal dome? Read 1. Increase the total height of overall product; 2. Increase the touch and click feeling … Continue reading

Posted in Metal Dome Assembly, Metal Domes | Leave a comment

What the reasons for poor conduction of metal dome?

We all know that the metal dome is very important for the conduction of electronic product, if the metal dome has problem, the whole product will be affected. Then whether a product has conduction problem and its must caused by … Continue reading

Posted in Metal Dome Assembly, Metal Domes, Others | Leave a comment

How to make super large size dome array like 150*200mm?

As we already know there are two methods to manufacture metal dome array: laser-cutting or tooling produce . Usually when the dome sheet exceed than 150mm we will suggest to open a tooling to produce it. Is this the only … Continue reading

Posted in metal dome array, Metal Dome Assembly | Leave a comment